Archive for the ‘lowering’ Tag

XS650: Fork Lowering   Leave a comment

Some time ago I posted ‘How to lower those Forks‘. Have always had misgivings about this method – it reduces the ammount of fork travel. OK if you dont push your bike.

It is true that our XS650s do suffer from posture. Front is a bit high/rear a bit low.

My blue rat runs an SR500 front drum brake. One of my SR500s runs with an XS650 fork.

Comparing the XS650 and SR500 upper yokes you can see marked differences. And similarities. Fork width and tube diameters are the same. Yoke height isnt. SR500 front sits lower as the yoke is flat.

 

1 .. unpainted SR500 upper yoke – painted XS650 one … (SR500 yoke has been a little modified-handlebar has been solid mounted and instrument cluster mounts have been remove

unpainted SR500 upper yoke – painted XS650 one … (SR500 yoke has been a little modified-handlebar has been solid mounted and instrument cluster mounts have been removed) – apart from that the geometry matches

 

2 .. you can see that the XS650 yoke mounts higher than the SR500 – translates to the fork tubes sitting lower and the front higher

you can see that the XS650 yoke mounts higher than the SR500 – translates to the fork tubes sitting lower and the front higher

 

3 .. here you can see the same – the difference is about 27mm or so

here you can see the same – the difference is about 27mm or so

 

Can definitely gain over an inch (ca 27mm) height change very easily without compromising fork travel.

Posted July 15, 2015 by xscafe in Frame - Forks

Tagged with , , ,

XS650: How to lower those forks   Leave a comment

I have been meaning to put this down in print for quite some time now but then I found this. It runs you through the process very well so I will simply link to it at Chop Cult.

Hugh ‘Punkskalar’ … XS650: How to lower those forks

 

1 .. Hughs' own

Hughs’ own

 

2 .. 17mm bolt used to hold the internals - later models

17mm bolt used to hold the internals – later models

 

4 .. ... like this

like this

 

 

Posted January 10, 2011 by xscafe in Frame - Forks

Tagged with , ,