XS650: Rocker Shafts   Leave a comment

Been building myself a couple of XS motors lately. 277° and 360°. Have had the blocks together for some time – gearbox and crank, new bearings and seals etc.

Got round to stripping down an old XS1 head the other day. Just to check her out. Actually not too bad, some leakage around the top of the inlet valves, guides ok, valve stems straight. Cam ok. Rockers starting to wear a little. Decided to replace them and the shafts as I had a new set lying around and I have a new cam.

First you need to remove the 4 press fit sleeves that seal the outer-headstuds. You can simply bash these out but I wanted to remove the rockers and the shafts sit pretty tight (unlike the SR500) so I popped the rockerbox in the oven for a while.

The sleeves knock out easily with an 8mm socket.

dscn0679

 

dscn0678

 

Then you can get to the rocker shafts. These are tight.The puller I had rustled up for the SR500 wasnt up for the job but still had the longest 6mm thread I had on hand so I simply packed the outside with a socket and an old gearbox bearing and wound the shafts out.

dscn0673

 

dscn0674

 

Total time, less than 5 minutes once heated (if you heat use the oven and not a torch – no point in risking warping the box).

Slapped her back into the oven for a few minutes before inserting the new shafts and rockers. Dont forget to blow out the oil galleries first, and lube.

If wanting to reuse remember to bag and label: left/right, inlet/outlet

enjoy

Advertisements

Posted May 29, 2016 by xscafe in Motor - Head, Uncategorized

Tagged with , ,

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: