XS650: Rocker Shaft Removal   Leave a comment

Have been cleaning up a couple of SR500 heads. Ready for porting, new valves and rocker shaft bushing. Needed to remove the shafts. Rooted around in the odds’n’sods bin.

  • 2 x pieces 6mm threaded rod
  • 1 x long open ended 6mm joiner
  • 2 x 6mm nuts
  • 1 x 6mm dome nut
  • 12 x large 6.5mm washers
  • 1 x piece duct tape

5 minutes. No cutting. A perfectly good 6mm slide hammer.

52c8e8bd-d629-44ef-ac95-4c49409fa2ca

Screw into the rocker shaft. Off you go.

20e76062-1251-4a1b-83e2-d7d89c7b78dc

Same principle for the XS.

 

Advertisements

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: