XS650: Copper Head Washers   Leave a comment

copper washers


Well. Those are pretty. Coppery.



original rubber coated washers


Rubber compresses. Hardens. Ages. Leaks.

These outside head studs are wet. Drain oil back to the crankcase.


oil comes into the head from above…splits to each rocker…some is sprayed, the rest follows the outer head studs to the crankcase


machined return galleries…each outside headstud


look like this


Copper washers on the outside head studs seal well. Allow securer torque settings.

Kits are available with 4 copper or brass washers and 4 steel ones for the 4 inside head studs.


washer kit


Can also use Suzuki GS750/1000 Cu washers part # 09168-10017

Or look for 22 x 10.5 x 4. Metric of course.


torque sequence


Don’t forget torque sequence. Diagonally opposed.

Torque in sequence. And in increments.

Don’t go direct to full torque in 1 hit. Take your time.

Clean threads. A little oil. No loctite.

Set torque. Leave the top mount off. Run to warm. Retorque. Test run. Retorque. 70-100 kms. Retorque. Top mount – don’t forget it.

Failure to do this, and check occassionally, leads to cylinder leaks.

Doing this to stop cylinder head leaks? Too late. Do the job properly. New head gasket. While you’re there do the cam chain, front guide, valve seals and valve grind.

And then………


Posted January 31, 2011 by xscafe in Motor - Cases, Motor - Head, Motor - Oil

Tagged with , , , , ,

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: